Intel SRCSAS18E User Manual

10

The following steps are for quick RAID Controller SRCSAS18E installation. These steps 

are for experienced computer users/installers. “Detailed Installation” contains the steps for 

all others to follow.

1. Turn power off to the system and all hard disk drives, enclosures, and system 

components. 

2. Remove the power cord from the server.
3. Follow the insructions in the server documentation to open the server chassis.
4. Check the jumper settings and memory module on the RAID controller.
5. Install the RAID Controller SRCSAS18E in the server and connect SAS or SATA 

devices to it. Ensure that the cables you use conform to all specifications.

6. Perform a safety check. 

— Ensure that all cables are properly attached. 
— Ensure that the RAID Controller SRCSAS18E is properly installed.
— Close the server chassis.

7. Reconnect power cable and turn on power.

This section provides detailed instructions for installing a RAID Controller SRCSAS18E. 

1. Unpack the Storage Adapter

Unpack and remove the RAID Controller SRCSAS18E. Inspect it for damage. If it 

appears damaged, or if any items listed below are missing, contact your Intel sales 

representative. The RAID Controller SRCSAS18E is shipped with:
— The Resource CD, which contains drivers for supported operating systems, an 

electronic version of this User’s Guide, and other related documentation

— A license agreement

2. Power Down the Server

Turn off the computer and remove the AC power cord. Remove the server chassis 

cover. Refer to the server documentation for instructions.

3. Check the Jumpers

Ensure that the jumper settings on the your RAID Controller SRCSAS18E are correct. 

See Chapter 3 for a diagrams of the RAID Controller SRCSAS18E.

4. Check the Memory Module