Motorola MTM5400 User Manual

46

MTM5400 Mobile Terminal Installation Manual

INSTALLATION

8.

Verify that the antenna cable is routed in the shortest way to minimize power loss over the 

cable.

9.

Check that the mounting surfaces are able to support the weight of the units.

Figure 16  Motorcycle Installation

Installing the Motorcycle Mount Enhanced Control Head

1.

Slide the Motorcycle Mount Enhanced Control Head onto the mounting trunnion until it snaps 
into place.

2.

Tighten the screws at both sides of the trunnion. After a few turns, tilt the Motorcycle Mount 

Enhanced Control Head for an optimum view of the display. Then, complete the tightening of 
the screws.

3.

There are two ways to mount the motorcycle trunnion, each limited to a 77 degree of 

allowable movement, as shown in Figure 17 and Figure 18:

If an additional GPS antenna or a combined TETRA/GPS 
antenna is used, the antenna housing carries the GPS 
receiver. Take care not to cover the antenna housing with 
metal or other radio wave absorbing material.

TRANSCEIVER 

LOUDSPEAKER 

FIST MICROPHONE 

MOTORCYCLE BOX 

ANTENNA 

BATTERY 

FUSE 

BLOCK 

CHASSIS GROUND 

FUSED POWER CABLE 

P/N: GKN6270 (3m, FUSE 10A) 

 

 

MOTOCYCLE MOUNT ENHANCED CONTROL HEAD 

TRANSCEIVER-TO-CONTROL HEAD CABLE 

P/N: PMKN4030 

FIST MICROPHONE CABLE

P/N: PMKN4029

use with the Mic or Handset