D-Link DFL-200 User Manual
Enable User Authentication via HTTP / HTTPS
Follow these steps to enable User
Authentication.
Authentication.
Step 1. Enable the checkbox for User
Authentication.
Authentication.
Step 2. Specify if HTTP and HTTPS or
only HTTPS should be used for the login.
only HTTPS should be used for the login.
Step 3. Specify the idle-timeout, the time a user can be idle before being logged out by the
firewall.
firewall.
Step 4. Choose new ports for the management WebUI to listen on as the user
authentication will use the same ports as the management WebUI is using..
authentication will use the same ports as the management WebUI is using..
Click the Apply button below to apply the setting or click Cancel to discard changes.
Enable RADIUS Support
Follow these steps to enable RADIUS
support.
support.
Step 1. Enable the checkbox for
RADIUS Support.
RADIUS Support.
Step 2. Fill in up to two RADIUS servers.
Step 3. Specified which mode to use, PAP or CHAP.
Step 3. Specify the shared secret for this connection.
Click the Apply button below to apply the setting or click Cancel to discard changes.