Sony WS615 Manual

 button

 button

 button located 

) part for 3 seconds to 

) part.

ÿ

¼ Hint

ÿ

ˎ For detailed instructions for transferring music to your Walkman and 

listening to music stored on your smartphone, refer to the Help Guide.

ÿ

ˎ To turn off your Walkman, press and hold the  button for 3 seconds.

VOL +/– button

 button

Lamp

 

 button

 button

Antenna

The Remote Commander is turned on by pressing and holding the  

 button for 2 seconds, and the lamp starts blinking. When 

the Remote Commander is connected to your Walkman, the lamp 
goes off.

If your Walkman does not function as expected, try the following steps to 
resolve the issue.

 

ÿ

ˎ

Attach your Walkman to the USB cradle (supplied) properly and firmly. 

Charging will start (the OPR lamp lights up in orange) even if the 

connection was not made properly, but there is a possibility that the 

computer has not recognized the Walkman. In such a case, remove 

the Walkman from the USB cradle and then attach to the USB cradle 

again.

ÿ

ˎ

If the remaining battery power is low or insufficient, charge the 

battery.

ÿ

ˎ

When you use your Walkman for the first time, or if you have not used 

the Walkman for a long time, it may take a few minutes to be 

recognized by the computer, even if charging has already started (the 

OPR lamp lights up in orange). Check that the computer recognizes 

the Walkman after you have connected it to the computer for about 

10 minutes.

ÿ

ˎ

If the support profiles are different, your Walkman and Bluetooth 

device cannot be paired. For more information, refer to the 

“Specification” section on the Help Guide.

ÿ

ˎ

Check that the Bluetooth function is activated on the smartphone and 

your Walkman.

ÿ

ˎ

Check that the model name of your Walkman is shown as being 

connected on the [Settings] - [Bluetooth] screen of the smartphone. If 

the Walkman is not connected, tap the model name.

ÿ

ˎ

Make sure that the Remote Commander is turned on.

ÿ

ˎ

Make sure that your Walkman is turned on.

ÿ

ˎ

Reset the Remote Commander and your Walkman. For more 

information, refer to the “You cannot operate your Walkman by the 

Remote Commander.” section on the Help Guide.

ÿ

ˎ

You cannot use the Remote Commander when it is wet. Dry the 

Remote Commander using a dry cloth.

ÿ

ˎ

Replace the battery of the Remote Commander. For more information, 

refer to the “Replacing the battery of the Remote Commander” 

section on the Help Guide.

The earbuds seal your ears. Therefore, be aware that there is a risk of damage 

to your ears or eardrums if strong pressure is applied to the earbuds or the 

earbuds are suddenly removed from your ears. After use, be sure to take the 

earbuds off your ears gently.

ÿ

ˎ Avoid playing the unit at so loud a volume that extended play might affect 

your hearing.

ÿ

ˎ At a high volume outside sounds may become inaudible. Avoid listening to 

the unit in situations where hearing must not be impaired, for example, 

while driving or cycling.

ÿ

ˎ As the headphones are of open-air design, sounds go out through the 

headphones. Remember not to disturb those close to you.

If tanning oil or sunscreen gets onto your Walkman or the Remote 

Commander, wash it off using lukewarm water. Otherwise, it may cause 

discoloration or damage such as cracks to occur.

The model and serial numbers are located on the back of the player. Record 

them in the space provided below. Refer to these numbers in the spaces 

whenever you call upon your Sony dealer regarding this product.
Model No. ________________________
Serial No._________________________

TRA

REGISTERED No: ER34837/14
DEALER No: DA0096946/12

ÿ

ˎ For information on laws, regulations and trademark rights, refer to 

“Important Information” contained in the supplied software. To read it, 

install the supplied software on your computer.

ÿ

ˎ Apple, the Apple logo, iPhone, iPod, iPod touch, iTunes, Mac, iOS and OS X 

are trademarks of Apple Inc., registered in the U.S. and other countries. 
App Store is a service mark of Apple Inc.

ÿ

ˎ “Made for iPod,”and“Made for iPhone,” mean that an electronic accessory 

has been designed to connect specifically to iPod, or iPhone, respectively, 

and has been certified by the developer to meet Apple performance 

standards. Apple is not responsible for the operation of this device or its 

compliance with safety and regulatory standards. Please note that the use 

of this accessory with iPod, or iPhone may affect wireless performance.

ÿ

ˎ Compatible iPhone/iPod models 

Bluetooth technology works with iPhone 5s, iPhone 5c, iPhone 5, 

iPhone 4s, iPhone 4, iPhone 3GS, and iPod touch (4th and 5th 

generation).

Design and specifications are subject to change without notice.

RESET 

button

Pairing can be started only when the Bluetooth mode of your Walkman is 
off.

Press and hold the   button 
located on the left (

) part 

for 7 seconds.
The Bluetooth lamp located 
on the left (

) part blinks in 

blue and red quickly 
alternately.
When connecting your 
Walkman and smartphone 
from the second time 
onwards, press and hold the 

 button for 2 seconds.

button

Follow the on-screen instructions to complete the settings.
When the list of detected devices appears, select [NWZ-WS613] or 
[NWZ-WS615].
If passkey input is required, input “0000.”

Your Walkman and the smartphone are registered to each other and a 
connection is made.

ÿ

¼ Hint

ÿ

ˎ You can pair your Walkman and smartphone using the one-touch (NFC) 

function. Refer to the Help Guide installed on your computer or at the URL 

mentioned in the “About the manuals” section on the cover page of this 

manual for details.

) and right ()