Renesas R5S72621 User Manual
Section 14 Realtime Clock
Page 704 of 2108
R01UH0134EJ0400 Rev. 4.00
Sep
24,
2014
SH7262 Group, SH7264 Group
14.5
Usage Notes
14.5.1
Register Writing during Count
The following registers cannot be written to during a count (while bit 0 = 1 in RCR2).
RSECCNT, RMINCNT, RHRCNT, RDAYCNT, RWKCNT, RMONCNT, RYRCONT
The count must be stopped before writing to any of the above registers.
14.5.2
Use of Realtime Clock Periodic Interrupts
The method of using the periodic interrupt function is shown in figure 14.5.
A periodic interrupt can be generated periodically at the interval set by bits PES2 to PES0 in
RCR2. When the time set by bits PES2 to PES0 has elapsed, the PEF is set to 1.
RCR2. When the time set by bits PES2 to PES0 has elapsed, the PEF is set to 1.
The PEF is cleared to 0 upon periodic interrupt generation or when bits PES2 to PES0 are set.
Periodic interrupt generation can be confirmed by reading this bit, but normally the interrupt
function is used.
Periodic interrupt generation can be confirmed by reading this bit, but normally the interrupt
function is used.
Set PES2 to PES0
and clear PEF to 0
in RCR2
and clear PEF to 0
in RCR2
Clear PEF to 0
Set PES, clear PEF
Elapse of time set by PES
Clear PEF
Figure 14.5 Using Periodic Interrupt Function
14.5.3
Transition to Standby Mode after Setting Register
When a transition to standby mode is made after registers in this module are set, sometimes
counting is not performed correctly. After making register settings, do not fail to perform a
dummy read of the registers to which settings were made before entering the standby state.
counting is not performed correctly. After making register settings, do not fail to perform a
dummy read of the registers to which settings were made before entering the standby state.