A&D GP-102K User Manual

 

 79

Set the following parameters to use the AD-8121B printer. 

Function setting 

Description 

dout  prt   0-3 

Selects a print mode. 

dout ap-p  0-2 

Selects the polarity for the auto print mode. 

dout ap-b  0-2 

Selects the auto print difference. 

dout pU5e  0,1 

Selects data output pause. 

5if bp5  2 

Factory setting 

2400 bps 

5if btpr 0  Factory setting 

7 bits, Even parity check 

5if Crlf 0  Factory setting 

CR, LF 

5if Ct5  0  Factory setting 

CTS and RTS control, not used 

 

When “MODE 1” or “MODE 2” of the AD-8121B printer is used 
dout 5-td  0 

Factory setting 

Not to output the time and date. 

dout 5-id  0 

Factory setting 

Not to output the ID number. 

dout at-f  0 

Factory setting 

Not to use auto feed. 

5if type 0 

Factory setting 

A&D standard format 

 

When “MODE 3” of the AD-8121B printer is used. 
dout 5-td 0-3 

Outputs the time and date as necessary. 

dout 5-id 0,1 

Outputs the ID number as necessary. 

dout at-f 0,1 

Uses auto feed as necessary. 

5if type 1 

DP format 

 

When data is transmitted continuously. 
When all memory data is transmitted at one time. 
dout pU5e  1 

Uses pause. 

Setting 

What is printed 

data 0 

The weighing data   

data 2 

The weighing data stored in memory   

data 3 

The calibration or calibration test data stored in memory   

Refer to “10. ID NUMBER AND GLP REPORT” for a print sample. 
 

The GP series balance is of the DCE type (Data Communication Equipment), which can be 

connected to a personal computer using the RS-232C interface.   

Before connection, read the personal computer manual thoroughly.   
Use a standard DCE cable for connection (cable type: straight-through). 
When the personal computer type is a DOS/V with a 9-pin port, use a straight-through cable with 

a 25-pin male connector and a 9-pin female connector.