Philips 9VD200 User Manual

Children should be supervised to ensure that they do not play with the appliance.

The baby monitor has an operating range of 200 meters/600 feet in open air. Depending on the 

surroundings and other disturbing factors, the operating range may be smaller (see section 

‘Operating range’, in chapter ‘Using the appliance’.
Caution

Use and store the appliance at a temperature between 10°C and 40°C.

Do not expose the baby unit and parent unit to extreme cold, heat or direct sunlight.

Make sure the baby unit and its cord are always out of reach of the baby (at least 1 metre/3 

feet away).

Never place the baby unit inside the baby’s bed or playpen.

Never cover the parent unit and the baby unit with anything (e.g. a towel or blanket).

Always place non-rechargeable batteries of the correct type in the baby unit and the parent 

unit.
general

This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult 

supervision and should not be used as such.
electromagnetic fields (eMF)

This Philips AVENT appliance complies with all standards regarding electromagnetic fields (EMF). If 

handled properly and according to the instructions in this user manual, the appliance is safe to use 

based on scientific evidence available today.

You can use the baby unit from the mains or on non-rechargeable batteries. Even if you are going to 

use the unit from the mains, we advise you to insert the non-rechargeable batteries. This guarantees 

automatic back-up in case of mains failure.

 1 

 Put the appliance plug in the baby unit and put the adapter into a wall socket (Fig. ).

The power-on light goes on.

The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use 

Philips LR6 PowerLife batteries.

Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert the non-

rechargeable batteries.

 1 

 Unlock the battery compartment lid by turning the locking knob with a coin. Then remove 

the lid (Fig. ).

  

 Insert four non-rechargeable batteries.

Make sure the + and - poles of the batteries point in the right direction.

  

 Reattach the battery compartment lid and close it by turning the locking knob with a coin.

When the batteries are low, the power light on the baby unit flashes red.

You can use the parent unit from the mains or on non-rechargeable batteries. Even if you are going 

to use the unit from the mains, we advise you to insert the non-rechargeable batteries. This 

guarantees automatic back-up in case of mains failure.

-

-

-

-

-

-

-

-

-

7