Graco ISPC008BA 08/02 User Manual

belt must be routed through 

opening in car seat for 

(see page 23, fig. k). 

Belt must lay flat and not be twisted. 

Adjust car seat to upright position (see pages
18 and 19, fig. b) and place 

on vehicle seat equipped with 

anchors.

For ease of installation, extend 

belt

to its maximum length.

Hook connectors to vehicle lower anchors 
(fig. a). Pull connectors to be sure they are 
securely attached (fig. b).

Press down firmly in center of car seat to 
compress vehicle seat cushion while tightening 

belt by pulling adjustment belt (fig. c).

Use your knee to press down in center of
car seat (fig. c).

Pull front to back and left to right to check for 
secure installation (fig. d). 

Check that the lower anchorage belt stays
tight and does not slip from the tightened 
position. If it does not stay tight, try another 
seating position or contact Customer Service 
(see back cover).

Attach tether strap hook (A) to anchor 
hardware (B) and tighten adjustment belt to 
remove any slack (fig. e). 

Periodically check that car seat is securely 
installed; adjust if necessary.