Epson 1810P User Manual

You see a projected message:

2. Aim the projector so the message appears near the middle of the 

screen. Then use the zoom ring to enlarge the image so the white 
frame (not shown above) extends beyond the edges of the screen 
on all sides.

3. Press the 

Quick Setup

 button again. Two white boxes flash 

momentarily onto the screen, and the adjustment is complete. 
Your projected image now fits on the screen (some slight overlap 
is normal).

The Quick Setup adjustment is retained when the projector is turned 
off. If the projector is installed in a fixed location, you won’t need to 
repeat the adjustment each time you turn it on. To fine-tune the 
Quick Setup adjustment, use Quick Corner

®

 (below).

Use Quick Corner to adjust the shape and size of the image when it’s 
uneven on all sides, or to finely adjust the image after performing 
Quick Setup. If you just used Quick Setup, you can use the projector’s 
arrow buttons to make the Quick Corner adjustment. If not, you’ll 
have to select 

Quick Corner

 as follows: 

1. Press the 

Menu

 button on the remote control or on the 

projector’s control panel.

2. Select the 

Settings

 menu and press 

Enter

. 

3. From the Settings menu, select 

Keystone

 and press 

Enter

. 

4. Select 

Quick Corner 

and press 

Enter

.

If Quick Setup did not 
detect the edges of your 
screen (for example, if you’re 
projecting on a wall), then 
the arrow buttons will be in 
Keystone correction mode 
after performing Quick 
Setup (see page 24).

User's Guide - 1810.book  Page 23  Monday, September 10, 2007  6:39 PM