JVC KD-G115 User Manual

17

ENGLISH

•  If you turn off the power while listening to a 

disc, disc play will start from where playback 
has been stopped previously, next time you 
turn on the power.

•  During SSM search...
  – All previously stored stations are erased and  

stations are stored newly.

   – Received stations are preset in No. 1 (lowest 

frequency) to No. 6 (highest frequency). 

   – When SSM is over, the station stored in 

No. 1 will be automatically tuned in.

•  When storing a station manually, a previously 

preset station is erased when a new station is 
stored in the same preset number.

•  This receiver has been designed to reproduce 

CDs, and CD-Rs (Recordable)/ CD-RWs 
(Rewritable) in audio CD (CD-DA) format.

•  When a disc has been loaded, selecting “CD” 

for the playback source starts disc play.

•  When a disc is inserted upside down, the disc 

automatically ejects.

•  Do not insert 8 cm discs (single CD) and 

unusual shape discs (heart, flower, etc.) into 
the loading slot.

•  Use only “finalized” CD-Rs or CD-RWs.
•  This receiver can play back multi-session 

discs; however, unclosed sessions will be 
skipped while playing.

•  Some CD-Rs or CD-RWs may not play 

back on this receiver because of their disc 
characteristics, and for the following causes:

  – Discs are dirty or scratched.
  – Moisture condensation occurs on the lens 

inside the receiver.

  – The pickup lens inside the receiver is dirty.
  – CD-R or CD-RW on which the files are 

written with “Packet Write” method.

  – There are improper recording conditions 

(missing data, etc.) or media conditions 
(stain, scratch, warp, etc.).

•  CD-RWs may require a longer readout time 

since the reflectance of CD-RWs is lower 
than that of regular CDs.

•  Do not use the following CD-Rs or 

CD-RWs:

  – Discs with stickers, labels, or protective seal 

stuck to the surface.

  – Discs on which labels can be directly 

printed by an ink jet printer.

  Using these discs under high temperatures 

or high humidity may cause malfunctions or 
damage to discs.

•  If you change the source, playback also stops 

(without ejecting the disc).

  Next time you select “CD” for the playback 

source, disc play starts from where it has been 
stopped previously.

•  If the ejected disc is not removed within 

15 seconds, the disc is automatically inserted 
again into the loading slot to prevent it from 
dust. (Disc will not play this time.)

•  If you change the “AMP GAIN” setting from 

“HIGH PWR” to “LOW PWR” while the 
volume level is set higher than “VOL 30,” the 
receiver automatically changes the volume 
level to “VOL 30.”

EN14-19_KD-G116[U_UH]f.indd   17

10/7/04, 3:36:47 PM