Yamaha HTR-6160 User Manual

Press 8n to select “START” and then press 
8

ENTER to start the setup procedure.

The following message appears in the OSD.
When this unit starts the automatic setup procedure, 
loud test tones are output at the speakers. 
For more accurate measurements, keep quiet and 
move to the wall where speakers are not around. We 
recommend that you leave the listening room during 
the automatic setup procedure.

Once you perform the next operation, this unit starts 
the automatic setup procedure.

Press 8

ENTER to start the automatic setup 

procedure.
The following screen appears in the OSD and setup 
procedure starts in 10 seconds.

Loud test tones are output from each speaker during 
the auto setup procedure. Once all items are set, the 
“RESULT” display appears in the OSD.

• During the automatic setup procedure, do not perform any 

operation on this unit.

• We recommend that you get out of the room while this unit 

is in the auto setup procedure. It takes approximately 3 
minutes for this unit to complete the auto setup procedure.

y
Press 8k to cancel the automatic setup procedure.

Make sure that the following screen appears 
and then press 8

ENTER to display the 

The results displayed under “RESULT” are as 
follows:

SP

Displays the number of speakers connected to this 
unit in the following order:
Front/Back/Subwoofer

DIST

Displays the speaker distance from the listening 
position in the following order:
Closest speaker distance/Farthest speaker distance

LVL

Displays the speaker output level in the following 
order:
Lowest speaker output level/Highest speaker output 
level

• The signal output at the SUBWOOFER PRE OUT 2 jack 

is the same as the one output at the SUBWOOFER PRE 
OUT 1 jack. Therefore, even if you connect two 
subwoofers, the number of the connected subwoofer is 
indicated as “0.1”.

• If “E-10:INTERNAL ERROR” appears during the testing 

procedure, restart from step 4.

• If you selected other than “AUTO” in step 5, no test tones 

are output.

• If an error occurs during the “AUTO SETUP” procedure, 

the setup procedure is canceled and an error screen 
appears. For details, see “If an error screen appears” on 
page 36.

• When this unit detects potential problems during the 

“AUTO SETUP” procedure, “WARNING” and the 
number of warning messages appears in the above of 
“RESULT” (see page 36).

• Depending on the listening environment, “SWFR 

PHASE:REV” appears during the automatic procedure 
and “SUBWOOFER PHASE” in “SOUND MENU” (see 
page 87) is automatically set to “REVERSE”.

NOTICE

output.

  

Loudtesttonesare

Pleasekeepquiet
orleavetheroom.

Press[ENTER]

AUTOSETUP

MeasurementStart

in 9seconds

[RETURN]:Cancel

AUTOSETUP

 RESULT

SP

:

3/4/0.1

DIST: 14.0/17.0ft
LVL : -9.0/+6.5dB

. SET CANCEL

[ ]/[ ]:Up/Down
[ENTER]:Enter

>

AUTOSETUP

Measurement Complete

Press [ENTER]