Vulcan-Hart ML-126452 User Manual

– 5 –

Immediately after unpacking the oven, check for possible shipping damage. If oven is found to be
damaged after unpacking, save the packaging material and contact the carrier within 15 days of
delivery.

Prior to installation, test the electrical service to assure that it agrees with the specifications on the
machine data plate located on the right side panel near the controls.

The ovens and warmers are secured to the skid with four screws which must be removed.

WARNING: THE OVEN SHOULD NOT BE ACCESSIBLE TO THE CUSTOMER. HOT GLASS AND
PARTS CAN CAUSE BURNS.

The oven may be placed where cooking may be observed to enhance customer awareness, but  must
be installed on a level surface.

The installation location must allow adequate clearances for servicing and for proper operation of the
front and rear doors.

• A minimum wall clearance of 10" (254 mm) from any glass, and 4" (101.6 mm) from each side

panel must be maintained.

Each oven and warmer is furnished on 1

9

/

16

" (39.7 mm) legs. Casters come with the stacking kit or can

be ordered as an accessory.

Place the two bottom plates in oven. The two plates slant to the middle to allow fat to drip into the grease
drawer (Fig.1).

PL-41161