Radio Shack HTX-200 User Manual
31
USING THE CALLING-FREQUENCY
MEMORY
MEMORY
The calling-frequency memory location lets you quickly jump to a
specific frequency at any time. The default calling frequency is
146.52 MHz. You can store a different frequency into memory as
well as other settings associated with that frequency, such as the
repeater offset and CTCSS tone.
specific frequency at any time. The default calling frequency is
146.52 MHz. You can store a different frequency into memory as
well as other settings associated with that frequency, such as the
repeater offset and CTCSS tone.
1. Press
C
to display the current calling frequency.
2. To change the frequency, hold down
C
until
and
C
flash.
3. Select a frequency. See “Selecting Frequencies (Direct Tun-
ing)” on Page 23.
4. Press
C
to store the selected frequency in memory.
5. To enter a frequency offset for repeater operation, press
FUNC+SC
. The HTX-200 displays the current offset for the
calling frequency. To select a new offset value, press
or
. Select 0.0 Hz if you want to remove the offset. To store
the setting, press
PTT
.
6. To select the offset direction (+ or –), press
FUNC + REV.
To
remove an offset for simplex operation, set the repeater off-
set to
set to
0.0
.
Note: While
and
C
appear, you can program other set-
tings such as CTCSS tones (see “Continuous Tone Coded
Squelch System Features” on Page 35.)
Squelch System Features” on Page 35.)
To enable the calling frequency, press
C
at any time. The trans-
ceiver immediately tunes to that frequency with the settings you
programmed. To exit the calling frequency mode, press
programmed. To exit the calling frequency mode, press
C
again.
MR
MR
19-1102RPO.fm Page 31 Friday, June 25, 1999 11:17 AM