Ryobi P2105 User Manual

7 — English

Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is 
sufficient to inflict serious injury.

Always wear eye protection with side shields marked to 
comply with ANSI Z87.1, along with hearing protection. 
Failure to do so could result in objects being thrown into 
your eyes resulting in possible serious injury.

Do not use any attachments or accessories not recom-
mended by the manufacturer of this product. The use of 
attachments or accessories not recommended can result 
in serious personal injury.

You may use this product for the purposes listed below:


Clearing hard surfaces such as driveways and walkways



Keeping decks and driveways free from leaves and pine 
needles

This product will accept Ryobi One+ 18 V lithium-ion battery 
packs and Ryobi One+ 18 V nickel-cadmium battery packs. 
For complete charging instructions, refer to the Operator’s 
Manuals for your Ryobi One+ battery pack and charger 
models.

See Figure 3.


  To start the blower, place the power switch in the 

ON  ( l ) 

position.



  To stop the blower, place the power switch in the 

( O )  position.

Always remove battery pack from your tool when you are 
assembling parts, making adjustments, cleaning, or when 
not in use. Removing battery pack will prevent accidental 
starting that could cause serious personal injury.

To install:


  Place the power switch in the 

OFF  ( O ) position.



  Place the battery pack in the blower. Align raised rib on bat-

tery pack with groove in the blower’s battery port.

  Make sure the latches on each side of the battery pack snap 

in place and that battery pack is secured in the blower before 

beginning operation.

When placing battery pack in the blower, be sure 
raised rib on battery pack aligns with the back of 
the blower and latches into place properly. Improper  
installation of the battery pack can cause damage to 
internal   components.

To remove: 


  Place the power switch in the 

OFF  ( O ) position.



  Locate latches on side of battery pack and depress both 

sides to release battery pack.



  Remove battery pack from the blower.

See Figure 5.


  To keep from scattering debris, blow around the outer edges 

of a debris pile. Never blow directly into the center of a pile.



  To reduce sound levels, limit the number of pieces of equip-

ment used at any one time.



  Use rakes and brooms to loosen debris before blowing. In 

dusty conditions, slightly dampen surfaces when water is 

available.



  Conserve water by using power blowers instead of hoses for 

many lawn and garden applications, including areas such as 

gutters, screens, patios, grills, porches, and gardens.



  Watch out for children, pets, open windows, or freshly 

washed cars, and blow debris safely away.



  After using blowers or other equipment, CLEAN UP! Dispose 

of debris properly.

Battery tools are always in operating condition. Therefore, 

switch should always be in the OFF position when not in use 

or carrying at your side.