Roberts Radio RDK-2 User Manual

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

1.  Position your RDK2 touch panel radio as previously described.

2.  Plug the mains plug into a wall socket and switch on the wall 

socket.

The mains plug is used as the means of connecting 

 

the radio to the mains supply. The mains socket used 

 

for the radio must remain accessible during normal use. In order 

 

to disconnect the radio from the mains completely, the mains 

 

plug should be removed from the mains socket outlet 

 completely.

 

8.  Completely undo the thumb screws from the sides of the radio and 

remove the mounting bracket.

9.  Hold the mounting bracket against the pencil marks under the cupboard 

and use the pencil to mark drill centres for the fi xing screws (4).

10.  Your radio is supplied with screws of two lengths. Be sure to use screws 

of appropriate length for the cupboard material. If those provided are 
not suitable for your needs, please use screws with a similar diameter 
and head design.

11.  Drill short pilot holes for the screws in the underside of the cupboard. 

(Pilot hole diameter typically 2.5mm, suggested drill depth not more 
than 12 - 14 mm)

12. Using the screws to fi t the mounting bracket to the cupboard taking 

care not to over tighten them.

13. Offer the radio to the fi xed mounting bracket and re-insert the two 

thumb screws.

14. Adjust the height of the radio beneath the cupboard as needed and 

tighten the thumb screws. Tighten by hand only.

15. Secure the mains lead and aerial as needed. The aerial has a loop 

formed at the free end. This can be fi xed as needed. Insert the mains 
plug in the nearest convenient mains socket and secure the mains 
lead so that it does not obstruct working in the kitchen.