JVC GVT0289-025A Leaflet

Select a place which is level, dry, and neither too hot nor too cold; between 
5°C and 35°C.
Leave sufficient distance between the System and the TV.
Do not use the System in a location near heat sources, or in a place subject to 
direct sunlight, excessive dust, or vibration.
Install the System in a location with adequate ventilation to prevent internal 
heat buildup.

Do not handle the power cord with wet hands.
A small amount of power is always consumed while the power cord is 
connected to the wall outlet.
Do not pull on the cord to unplug the power cord. When unplugging the 
power cord, always grasp and pull the plug so as not to damage the cord.

There are no user-serviceable parts inside. If anything goes wrong, unplug 
the power cord and consult your dealer.
Do not insert any metallic objects or liquids into the System.

Avoid moisture, water, and dust
Do not place the System in moist or dusty places.
Avoid high temperatures
Do not expose the System to direct sunlight and do not place it near any 
heating devices.
When you are away
When away on holiday or for other reasons for an extended period of time, 
disconnect the power cord from the wall outlet.
Do not block the vents
Blocking the vents may damage the System.

•

•
•

•

•
•

•

•

•

Output power
Center/ Front Surround:  

120 W (30 W × 4), at 4 

Audio section
Analog Input 

ANALOG: 1 Vrms/50 k

Ω

Digital Input* 

DIGITAL 1, DIGITAL 2: –21 dBm to –15 dBm 
(660 nm ±30 nm)

Speaker section
Type: 

Full-Range Bass-Reflex Type (Magnetically-
Shielded Type)

Speaker: 

8 cm cone × 4

Power Handling Capacity: 

30 W

Impedance: 4 

Ω

Frequency Range: 

Center Speakers: 84 Hz to 22 kHz

 

Front Speakers: 84 Hz to 22 kHz

Sound Pressure Level: 

Center Speakers: 82 dB/W•m

 

Front Speakers: 82 dB/W•m

General
Power Source (DC IN): 

DC19 V 

 3.37 A

AC adaptor (AA-R1902): 

Input: AC 110-240 V

 1.5-0.9 A, 50/60 Hz

Output: DC19 V 

 3.37 A

Dimensions (W × H × D): 

900 mm ×125 mm × 85 mm

Mass:  

3.5 k

g

Output power 

Type: 1-Way 

Bass-Reflex 

Type

Speaker: 

16 cm cone × 1

Power Handling Capacity: 

100 W

Impedance: 3 

Ω

Frequency Range: 

45 Hz to 5 kHz

Sound Pressure Level: 

82 dB/W•m

Power Requirements: 

AC 110 - 127 V/220 - 240 V

, adjustable 

with the voltage selector

 50/60 

Hz

Power Consumption:  

30 W (during operation)

 

1.00 W or less (in Standby mode)

Dimensions (W × H × D): 

215 mm × 352 mm × 254 mm

Mass: 5 

k

g

Stains on the System should be wiped off with a soft cloth. If the System 
is heavily stained, wipe it with a cloth soaked in water diluted neutral 
detergent and wrung well, then wipe clean with a dry cloth.
Since the System may deteriorate in quality, become damaged or get its 
paint peeled off, be careful about the following:

DO NOT wipe it forcefully.
DO NOT wipe it with thinners, benzines or other organic solvents including 
disinfectants.
DO NOT apply any volatile substances such as insecticides to it.
DO NOT allow any rubber or plastic to remain in contact with it for a long 
time.

Do not place anything on top of the System. Doing so may cause the System 
to fall, causing malfunctioning and/or injury.
The manufacturer accepts absolutely no liability for any accidents or damage 
resulting from inadequate assembly or mounting, insufficient strength of 
attachment, misuse or abuse, or natural disasters.

If water gets inside the System
Turn the System off and disconnect the power cord from the wall outlet, 
then call the store where you purchased this System. Using the System in this 
condition may cause a fire or electrical shock.

Check to make sure you have all of the supplied accessories.
If anything is missing, contact your dealer immediately.

Remote control RM-STHBA3A (× 1)
AC adaptor (AA-R1902) (× 2)
AC plug adaptor (× 3)
AC power cord (× 2)
Lithium coin battery CR2025 (× 1)

The battery has been installed in the remote control when shipped from 
the factory.

Core filter (large) (× 3)

For the DC power cord and external components cords 

Core filter (small) (× 1)

For surround speaker cords

•

•

•

•

•
•
•
•
•

•

•

Output power: 

Power Source (DC IN): 

DC19 V 

 3.37 A

AC adaptor (AA-R1902): 

Input: AC 110 – 240 V 

 1.5-0.9 A,

50/60 Hz

 

Output: DC 19 V 

 3.37 A

Dimensions (W × H × D): 

186 mm × 30.8 mm × 300 mm

Mass: 0.53 

k

g

Type: Full-Range 

Bass-Reflex 

Type

Speaker: 

8 cm cone × 1

Power Handling Capacity: 

30 W

Impedance: 4 

Ω

Frequency Range: 

84 Hz to 22 kHz

Sound Pressure Level: 

82 dB/W•m

Dimensions (W × H × D): 

105 mm × 118 mm × 98 mm

Mass: 0.46 

k

g each

*  Corresponding to Linear PCM, Dolby Digital, and DTS (with sampling frequency 

Designs & specifications are subject to change without notice.

CAUTION for mains (AC) line
BEFORE PLUGGING IN, do check that your mains (AC) line voltage corresponds 
with the position of the voltage selector switch provided on the outside of this 
equipment and, if different, reset the voltage selector switch, to prevent from a 
damage or risk of fire/electric shock

CAUTION (SP-THBA3F)
The 

 button in any position does not disconnect the mains line.

Disconnect the mains plug to shut the power off completely (the STANDBY 
lamp goes off). The MAINS plug or an appliance coupler is used as the 
disconnect device, the disconnect device shall remain readily operable.

When the System is on standby, the STANDBY lamp lights red.
When the System is turned on, the STANDBY lamp goes off.

The power can be remote controlled.

CAUTION (SP-THBA3W/RX-THBA3)
The power supply to the subwoofer is linked to the center unit. Disconnect the 
mains plug to shut the power off completely (the POWER ON lamp goes off). 
The MAINS plug or an appliance coupler is used as the disconnect device, the 
disconnect device shall remain readily operable.

When the System is on standby, the STANDBY/ON lamp lights red.
When the System is turned on, the STANDBY/ON lamp lights blue.

CAUTION
Battery shall not be exposed to excessive heat such as sunshine, fire or the like.

CAUTION
To reduce the risk of electrical shocks, fire, etc.:

Do not remove screws, covers or cabinet.
Do not expose this appliance to rain or moisture.

Do not block the ventilation openings or holes. (If the ventilation openings 
or holes are blocked by a newspaper or cloth, etc., the heat may not be able 
to get out.)
Do not place any naked flame sources, such as lighted candles, on the 
apparatus.
When discarding batteries, environmental problems must be considered 
and local rules or laws governing the disposal of these batteries must be 
followed strictly.
Do not expose this apparatus to rain, moisture, dripping or splashing and 
that no objects filled with liquids, such as vases, shall be placed on the 
apparatus.

Do not use another AC adaptor to connect this model.

•
•

•
•

1.
2.

•

•

•

•

GVT0289-025A[UJ]

0710WMKMDWJMM

 EN

© 2010 Victor Company of Japan, Limited

Manufactured under license under U.S. Patent numbers: 5,451,942; 
5,956,674; 5,974,380; 5,978,762; 6,487,535 and other U.S. and 
worldwide patents issued and pending. DTS and DTS Digital Surround 
are registered trademarks and the DTS logos and Symbol are trademarks 
of DTS, Inc. © 1996-2008 DTS, Inc. All Rights Reserved.
Manufactured under license from Dolby Laboratories. Dolby, Pro Logic, 
and the double-D symbol are trademarks of Dolby Laboratories.

•

•

Thank you for purchasing a JVC product.
Before operation, please read the instructions carefully.

[European Union only]
[Union européenne seulement]

For SP-THBA3F, RX-THBA3, SP-THBA3S and SP-THBA3W
This device compiles with RSS-210 of Industry Canada Rules. Operation 
is subject to the following two conditions: (1) this device may not cause 
interference, and (2) this device must accept any interference, including 
interference that may cause undesired operation of the device.

For SP-THBA3F, RX-THBA3, SP-THBA3S and SP-THBA3W
This device complies with Part 15 of the FCC Rules. Operation is subject to the 
following two conditions: (1) This device may not cause harmful interference, 
and (2) this device must accept any interference received, including 
interference that may cause undesired operation.
Changes or modifications not expressly approved by the manufacturer for 
compliance could void the user’s authority to operate the equipment.

CAUTION: Proper Ventilation
To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows:

Front: No obstructions and open spacing.
Sides/Top/Back: No obstructions should be placed in the areas shown by the dimensions below.
Bottom: Place on the level surface. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more.

1.
2.
3.

Front

15 cm 

15 cm  

15 cm 

10 cm 

RX-THBA3 SP-THBA3S 

SP-THBA3S  SP-THBA3W

SP-THBA3F 

2 cm 

2 cm

TH-BA3

TH-BA3_UJ_2nd.indd   1

TH-BA3_UJ_2nd.indd   1

10.7.20   10:16:45 AM

10.7.20   10:16:45 AM