Smeg CSA19ID-6 User Manual
Instructions for the installer
2. INSTALLATION OF THE APPLIANCE
It is the law that all gas appliances are installed by authorised persons.
Clearance around the cooker must comply with the requirements of
AGA601.
Clearance around the cooker must comply with the requirements of
AGA601.
2.1 Electrical connection
Make sure that the power line voltage matches the specifications
indicated on the rating plate located inside the storage compartment.
This rating plate must never be removed.
indicated on the rating plate located inside the storage compartment.
This rating plate must never be removed.
On the power line, install a two-pole cut-off device with contact cut-off
distance greater than or equal to 3 mm, located in an easily accessible
position near the unit.
distance greater than or equal to 3 mm, located in an easily accessible
position near the unit.
If the power cable is replaced, the wire section
on the new cable must not be less than
2.5 mm
on the new cable must not be less than
2.5 mm
2
(3 x 2.5 cable), keeping in mind that
the end to be connected to the cooker must
have the ground wire (yellow-green) longer by
at least 20 mm. Use only the special cables
available at our Service Centres.
have the ground wire (yellow-green) longer by
at least 20 mm. Use only the special cables
available at our Service Centres.
The manufacturer declines all responsibility for damage to persons
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
or things caused by non-observance of the above prescriptions or by
interference with any part of the appliance.
Overall dimensions: location of
gas and electrical connection
points (all measures in mm).
gas and electrical connection
points (all measures in mm).
6