American Standard 2088 Leaflet

M968712 REV. 1.2

Certified to comply with ANSI A112.18.1

For 3-hole (4" centers) installation, 
apply Putty to underside of Escutcheon (4)

and place over holes in lavatory sink with tab
towards back.

Feed faucet tubes through Rubber Ring (2)

and through hole in Escutcheon (4) or mounting

surface. Make sure Rubber Ring (2) is seated in

groove in base of Faucet (1). Escutcheon (4)

is optional on single hole lavatories.
From below, push Mounting Gasket (5) and

Mounting Washer (6) over Stud (3) and secure

with Nut (7), pushing Faucet (1) to back of sink,

so Stud (3) rests against sink hole. Before final

tightening, adjust Faucet (1) and Escutcheon (4)

so that they are centered.
Carefully bend and/or cut supply tubes and
connect left tube to HOT water and right
tube to COLD water supply using appropriate
connectors.

Plumbers' Putty or Caulking

Adjustable Wrench

3/32" Hex Key

Channel Locks

LAVATORY

PUTTY