Bosch FMR-1000-RCMD User Manual

Remote Command Center

 Mounting | en

Bosch Security Systems, Inc.

Installation and Operation Guide

F.01U.078.098 | 3.0 | 2011.11

System Overview

The Remote Command Center should be mounted no higher than shoulder height of the 

shortest person operating the system.

1.

The back box provides three knockouts for 1/2 in. diameter conduit connectors in the 

back, bottom and top side (refer to Figure 4.2, Item 1). To get a clean break, remove the 

knockout from the inside of the box.

2.

Install the back box with the arrow pointing up (refer to Figure 4.2, Item 2).

3.

Use the back box as a template to mark the location of the mounting holes (refer to 

Figure 4.2, Item 3). Provide an opening in the mounting surface for the wiring. Pre-start 

the screws. Do not secure the screws at this point.

4.

The built-in bubble level allows you to level horizontally without extra tools when 

securing the base (refer to Figure 4.2, Item 4).

FPA-1000

FMR-1000-RCMD FMR-1000-RA 

The device comes with the 

mounting material and language 

tabs in separate bags. For 

removing the device’s cover 

frame from the annunciator unit, 

hold the assembly and unlock 

the snap-fit hooks on one side. 

Pull the cover frame off.

Removing the Cover Frame (before Installation)

To get a clean break, remove the knockout from the inside of the box.