Panasonic CS-A9CKPG User Manual

■ Auto Operation Button

● Automatic Operation

• If the remote control fails to function or has been

misplaced, press the Auto Operation button to start
the Automatic operation.

• The Automatic operation will be activated

immediately once the Auto operation button is
pressed. However, temperature cannot be adjusted
when in this mode.

• The power indicator on the indoor unit will blink until

the operation mode is selected automatically.

• To cancel this operation, press once more.

● Remote Control Signal Receiving Sound

• To switch off the beep (Signal Receiving Sound),

press the Auto Operation button for 10 seconds
continuously or longer.

A “beep”, “beep” sound will be heard at the
tenth seconds.

Note : A “beep” sound will be heard at the fifth

seconds;
However please press continuously until you
heard “beep”, “beep” sound.

• Repeat the above steps if you want to switch on the

Signal Receiving Sound.

● (This is for Servicing purposes only.)

Note: If you press this button continuously for 5 to 10
seconds, Test Run operation will be performed. A
“beep” sound will be heard after five seconds
indicating the Test Run starts to operate.

■ Auto Restart Control

• If power is resumed after a power failure, the

operation will restart automatically after 3 - 4
minutes.

• Operation will be restarted automatically under the

previous operation mode and airflow direction when
power is resumed as the operation is not stopped
by the remote control.

■ Timer Setting

• When power failure occurs, the timer setting will be

cancelled. Once power is resumed, reset the timer.

■ Thunder and Lightning

• This air conditioner is equipped with a built-in surge

protective device. However, in order to further
protect your air conditioner from being damaged by
abnormally strong lightning activity, you may switch
off the circuit breaker.

• 

Raise the front panel and press.

■ Setting the Temperature

• Approximately 10% of electricity can be saved.
• Set the temperature higher or lower than the

desired temperature.

Cooling Model

Cooling Operation : 2°F higher

Heat Pump Model

Cooling Operation : 2°F higher
Heating Operation : 4°F lower

■ Air Filters

• Clean the air filters every 2 weeks.
• Dirty filters may reduces cooling or heating

efficiency.

■ Keep All Doors and Windows Closed

• Otherwise, cooling or heating performance will be

reduced and electricity cost is wasted.

■ Outdoor Unit

• Do not block the air outlet vents. Otherwise, it will

lower the cooling or heating performance.

■ Timer

• To prevent wastage of electricity, use Timer when

going out.

■ Avoid Direct Sunlight

• Keep curtains or drapes closed to avoid direct

sunlight during cooling operation.