Hearth & Home Technologies 823-0290 User Manual

R

Page 20

  September 1, 2008

250-5763C

 

See 

page 21 for operation considerations with 

a blower installed.

NOTE:  This stove is provided with 3 fiber door handles for 

the door, baffle by-pass handle and the top-load-
ing griddle slot.

1.  Using a 7/16 wrench, remove the 2 shipping bolts under-

neath the griddle before lifting the griddle off of stove.

2.  Open by-pass door by moving the side handle towards 

rear of stove.  

3.  Wait 15 seconds to allow smoke to clear out of firebox.
4.  Slowly open top loading door and load unit with fuel.
5.  Close the top door.
6.  Close the by-pass door (move side handle towards front 

of stove.)

with type of wood or chimney draft.   Due to altitude and 

for maximum operating efficiency with the lowest emissions, follow these operating procedures:
1.  Regardless of desired heat output, when loading stove, burn your Quadra-Fire with both air controls 

wide open for 5 to 15 minutes.

2.  Regulate burn rate (heat output) by using the Primary Air Slide Control (center under ashcatcher).  

The Start-Up Air Control (on the right) is used for initial start-up and reloading.

3.  Heat output settings are listed below, following 5 to 15 minutes of burning with controls wide open 

(

see #1 above):

4.  Burn dry, well-seasoned wood.

WARNING:  Do not operate with Start-Up Air 

Control  in  the  open  positionin  excess  of  15 

minutes!  Risk of extreme temperatures! Pro-

longed operation of this stove with the Start-

Up Air Control in the open position may cause 

the combustible materials around the stove to 

exceed safe temperature limits.

Below 10,000

10,000 - 15,000

15,000 - 40,000

Maximum Heat

Closed after 5 to 15 minutes

Closed after 5 to 15 minutes

Closed after 5 to 15 minutes

Closed after 5 to 15 minutes

Slide to right 

1/8 to 1/2" open (slide to left)

1/2” to 1-1/8" open (slide to left)

Fully open (all the way left