Mr. Coffee TM10 User Manual
Deliming
The Iced Tea
must be delimed when you begin to notice an increase in
heating time of the water in the brewer. This condition may be caused by a
buildup of lime and mineral deposits from your water.
The frequency of cleaning depends upon the hardness of the water used. The
following table gives the suggested cleaning intervals.
The frequency of cleaning depends upon the hardness of the water used. The
following table gives the suggested cleaning intervals.
(Read caution statement on the back of MR. COFFEE CLEANER packets
before use). Please follow these directions.
before use). Please follow these directions.
,
Fill the pitcher with warm water to the water level line marked on the
1.
2.
3.
4.
5.
6.
6.
7.
pitcher approximately 32 ounces.
Empty contents of one packet of MR. COFFEE CLEANER into the pitch-
er and stir with a plastic spoon until the cleaner Is completely dissolved.
This will make a clear blue solution.
Pour the blue solution onto the brewer. Let sit for 15 minutes. Place the
brewer, with lid, into the pitcher. Make sure the brewer, lid and pitcher fit
together snugly.
Follow steps 4-6 under “Cleaning Your Iced Tea Pot Before First
Use”, on page 6.
Use”, on page 6.
Thoroughly rinse the pitcher, brewer and lid.
Repeat steps l-5
with clean water only (no
blue solution). Continue to rinse out the unit until
If a normal brewing time is not achieved and tea stains remain, repeat
steps l-6.
SUGGESTED CLEANING INTERVAL
Type of Water
Cleaning Frequency
Soft Water
every 60 brew cycles
Hard Water
every 30 brew cycles
Your Iced Tea
may be cleaned using MR. COFFEE CLEANER or a mix-
ture of vinegar and water. For best results use MR. COFFEE CLEANER. It is
superior to vinegar and has no unpleasant odor. You may order MR. COFFEE
CLEANER by calling 1-80O-MR COFFEE (l-800-672-6333).
superior to vinegar and has no unpleasant odor. You may order MR. COFFEE
CLEANER by calling 1-80O-MR COFFEE (l-800-672-6333).
Using MR. COFFEE CLEANER:
Using Vinegar
1.
Unplug the machine before cleaning.
2.
Add a mixture of half water and half white distilled vinegar (16 fluid
ounces of each) to the brewer. Do not turn the unit on. Let sit for 30
minutes or longer until the deposits are removed, or repeat process until
the deposits are removed. DO NOT HEAT THE VINEGAR MIXTURE.
ounces of each) to the brewer. Do not turn the unit on. Let sit for 30
minutes or longer until the deposits are removed, or repeat process until
the deposits are removed. DO NOT HEAT THE VINEGAR MIXTURE.
Pour out and discard the vinegar mixture.
3.
Run one or two brew cycles using only fresh water to remove any
residual vinegar mixture.
9