Intel Desktop Board D945GRW BLKD945GRWLK User Manual
Product codes
BLKD945GRWLK
Intel Desktop Board D945GRW Technical Product Specification
60
2.7 Jumper Block
CAUTION
Do not move the jumper with the power on. Always turn off the power and unplug the power cord
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
from the computer before changing a jumper setting. Otherwise, the board could be damaged.
Figure 20 shows the location of the jumper block. The jumper block determines the BIOS Setup
program’s mode. Table 27 describes the jumper settings for the three modes: normal, configure, and
recovery. When the jumper is set to configure mode and the computer is powered-up, the BIOS
compares the processor version and the microcode version in the BIOS and reports if the two match.
program’s mode. Table 27 describes the jumper settings for the three modes: normal, configure, and
recovery. When the jumper is set to configure mode and the computer is powered-up, the BIOS
compares the processor version and the microcode version in the BIOS and reports if the two match.
OM19005
1
3
J41
Figure 20. Location of the Jumper Block
Table 27. BIOS Setup Configuration Jumper Settings
Function/Mode Jumper
Setting Configuration
Normal
1-2
1
3
The BIOS uses current configuration information and
passwords for booting.
passwords for booting.
Configure
2-3
1
3
After the POST runs, Setup runs automatically. The
maintenance menu is displayed.
maintenance menu is displayed.
Recovery
None
1
3
The BIOS attempts to recover the BIOS configuration.
Recovery media is required.
Recovery media is required.