Thermaltake VD2400BNS User Manual

Each motherboard has different standoff layout.  It is highly 
suggested that you refer to your motherboard's manual when 
installing motherboard into the Case.  The cases are applicable with 
Standard ATX, Micro ATX motherboards. 
Your motherboard may require a special I/O Panel, which should be 
included with your motherboard.

Placement Direction:
When installing the motherboard, make sure you follow the direction 
provided by your motherboard manufacturer.  On most standard 
motherboards, the edge with external ports goes to the rear part of the 
chassis.  It is highly recommended that you install CPU, heat sink and 
modular components before fixing the motherboard inside the chassis.

       = the locations of 
the screw holes.  Note 
these locations and 
place included 
standoffs on the chassis 
first.

This side towards 
the rear of the 
chassis

Above illustration is a sample of what 
the motherboard's layout. For more 
detail screw hole placement, please 
refer to your motherboard manual.

On the front of the case, you can find some LEDs and switch 
leads (POWER SW*1, POWER LED*1, H.D.D. LED*1, 
RESET SW*1, SPEAKER*1). 
Please consult user manual of your motherboard manufacturer, 
then connect these leads to the panel header on the 
motherboard. These leads are usually labeled; if not, please 
trace them back to the case front to find out their source.

    - POWER LED connects to your M/B at the PLED
    - POWER SW connects to the PWR connector on the 
                            motherboard.
    - H.D.D LED connects to the 2-pin labeled HDD LED 
                            connector.
    - RESET SW connects to the RSW connector on the 
                            motherboard,
    - SPEAKER connector: find out the 4-pin labeled SPEAKER 
                            on the M/B then connect it.