Philips LFF6080/GBB User Manual

- 47 -

This parameter allows you to configure your terminal 
accordingly to the type of network you will install it in.

1 Select the desired network type using the   or   

buttons 

 

- WLAN if using a wireless network

 

- LAN ETHERNET if using a wired network

2 Confirm with OK.

We recommend that you carry out a manual configuration 
of your terminal. The automatic configuration of the local 
network settings may be considered, if your local network 
features a DHCP or BOOTP server that can dynamically 
assign addresses to the peripheral devices present on the 
LAN.

To automatically configure the local network settings:

1 Choose Automatic and press OK to confirm. The 

terminal scans the local network for a DHCP or 
BOOTP server that can assign it its settings 
dynamically (the message S

 is 

displayed).

2 Once the message S

 has disappeared, 

check for the IP Address, Sub-network mask and 
Gateway address. If these are missing, you should 
carry out a manual configuration (see below).

To configure your terminal manually, you should obtain 
the usual information used to set a peripheral device (IP 
address, sub-network mask, network and gateway 
address).

To configure the local network setting manually:

1 Choose Manual and press OK to confirm.

1 Enter the IP address of your terminal and press OK 

to confirm.

1 Enter the sub-network mask of your terminal and 

press OK to confirm.

1 Enter the IP address of the network gateway and 

press OK to confirm.

The Ethernet card of your terminal already has an 
unmodifiable, yet consultable, IEEE address.

These names, which can be used with the network 
options, are used to identify your terminal machine from a 
PC connected to a local network (for instance with the 
name "IMP-NETWORK-1").

1 Enter the selected name (15 characters max) and 

press OK to confirm.

The WINS1 and WINS2 servers, used with the network 
options, allow access to terminals on other sub-networks 
by means of their NetBIOS name.