Snapper EZF2100DKU User Manual

 

PRE-START CHECK LIST 
Make the following checks and perform the 
service required before each start-up. 

2.1.1.  Check tires and add or release air as needed to 

bring pressure in drive tires to: 12 psi (Turf Type 
Tires), 5 psi (All Terrain Type Tires) and 25 psi in 
rear caster tires. Pressure in front deck caster 
wheels should be 25 psi. 

2.1.2.  Check guards, deflectors and covers to make 

sure all are in place and securely tightened. 

Check engine oil and add oil as needed to bring 
level up to the FULL mark. Refer to engine owner’s 
manual for oil specifications. See Figure 2.1.  

 

 

 
2.1.4. 

Check Blade switch to insure it works freely. Switch 
is pulled “OUT” for blade engagement or pushed 
back “IN” for blade disengagement. See Figure 2.2. 
IMPORTANT: Disengagement stops blades. 

 
 
 

 

 
 
 
 

2.1.5.  Clean exterior surfaces of cutting deck and 

engine of any accumulation of dirt, grass, oil, etc.  
Keep engine radiator air intake screen and 
cooling fins clear at all times. Check often in dry 
operating conditions. 

2.1.6.  Add fresh fuel to tank of the Out Front Z-Rider 

outside where fumes can safely dissipate. Make 
sure fuel filler cap is tight. Refer to engine 
owner’s manual for fuel specifications. 

2.1.7.  COLD ENGINE ONLY - Check engine coolant 

(antifreeze/water) and add coolant in the reserve 
tank as needed to bring level up to the FULL 
mark. Refer to engine owner’s manual for 
coolant ratio specifications. See Figure 2.3.  

 

 
 

 

 
2.1.8.  (Diesel Engine Models Only) Move fuel cock to 

the “ON” position. See Figure 3.8.  

 
 

This machine is equipped with a 

WARNING beeper. The beeper will sound when engine 
oil pressure is low or engine temperature is high. If this 
beeper sounds, stop operation immediately. Do not 
resume operation until the cause has been determined 
and proper action taken. Beeper function can be verified 
(with engine stopped) by turning key to “RUN” position.