Vulcan-Hart C24GA10 ML-136022 User Manual

Page of 39
F35425 (February 2006)
Page 4 of 40
C24GA SERIES CONVECTION STEAMERS - GENERAL
GENERAL
INTRODUCTION
Procedures in this manual will apply to all models
unless specified. Pictures and illustrations can be of
any model unless the picture or illustration needs to
be model specific.
INSTALLATION
Refer to the Installation and Operation Manual for
detailed installation instructions on steamers.
OPERATION
Refer to the Installation and Operation Manual for
specific operating instructions.
CLEANING
Refer to the Installation and Operation Manual for
specific cleaning instructions.
SPECIFICATIONS
Gas Line Pressures
Operating Pressure
Natural - Recommended  2.5” W.C.
Propane - Recommended 10.0” W.C.
Incoming Pressure
Natural - Recommended 7.0” W.C.  min.
Propane - Recommended 11.0” W.C. min.
Burner Air Pressure
0.4” W.C.
Electrical
Voltage:  120/60/1
Amps:  2.5 Amps
Frequency:  50/60 Hz
Water Supply
Supply pressure:  20-60 psig
Hardness*:  Less than 3 grains
Silica:  Less than 13 ppm
Total Chloride:  Less than 4.0 ppm
pH Range:  7 to 8
Undissolved Solids:  Less than 5 microns
(*17.1 ppm = 1 grain of hardness)
TOOLS
Standard
Standard set of hand tools.
VOM with A.C. current tester (Any quality VOM
with a sensitivity of at lease 20,000 ohms per volt
can be used.)
Special
Gas leak detection equipment.
Gas Manometer.
Loctite 271
Screwdriver, 1/8 X 4 cabinet tip