DCS PHFS-DW-SS User Manual

1) Remove reflector and emitter assembly by 

removing the screws that fasten the 
emitter assembly to the lower screen 
cone.

2) Remove valve panel; avoid tugging the 

ignition wire attached to backside of the 
valve panel at the igniter.

3) Remove the 1/4 NPT nut (using a 7/8 open

end wrench) which holds the burner head 
to the orifice fitting. Remove the burner.

Any debris in the opening of the burner
assembly can be cleared with a straightened
piece of coat hanger. Any rust can be
removed with a wire brush. Never use wood
or plastic objects to clear ports, wood or plas-
tic can break and block the ports.

Install the burner assembly by reversing the
(3) steps used for disassembly making certain
the burner assembly stands centered when
complete. After reassembly, the heater should
be tested observe the burner flame. It should
be as shown with the flame being blue with
slight yellow tipping.

Burner Removal And Installation

15

Emitter assembly

LOWER 

SCREEN CONE

1/4 NPT NUT

VALVE PANEL ASSEMBLY

PIEZO

IGNITER