Desa SBJ18VNA User Manual

www.desatech.com

114744-01B

OPERATING HEATER

Continued

OPTIONAL HAND-HELD

REMOTE OPERATION

Note:

All remote control accessories must be

purchased separately (see Accessories, page

27). Follow instructions included with the

remote control.

NOTICE: You must light the pilot

before using the hand-held re-

mote control unit. See

Lighting

Instructions on page 17.

After lighting, let pilot ﬂame burn for about

one minute. Turn control knob to ON posi-

tion. Adjust ﬂame adjustment knob anywhere

between HI and LO. Flip AUTO/OFF/ON

switch to AUTO. Slide the selector switch

to the REMOTE position (see Figure 20).

Note:

The burner may light if hand-held

remote was on when selector switch was last

turned off. You can now turn the burner on and

off with the hand-held remote control unit.
IMPORTANT:

Do not leave the selector switch

in the REMOTE or ON position when the pilot

is not lit. This will drain the battery.

Figure 20 - Setting the Selector Switch,

Control Knob and Flame Adjustment

Knob for Remote Operation

Selector Switch in
REMOTE Position

ON/OFF SERIES (MODEL GHRCB)

Hold the control button on the hand-held re-

mote until burner turns on. Hold the control

button again until burner turns off (see Figure

21, page 19).
To Lock

press both buttons on hand-held

remote control until light stops ﬂashing. Hand-

held remote control is now locked. If the ﬁre is

on it will be turned off automatically. In the

locked state, the light will not light up when

any button is pressed.
To Unlock

press both buttons together on hand-

held remote control until the light stops ﬂashing.

The hand-held remote is now unlocked.

REMOTE
OFF
ON

Piezo
Ignitor

Control Knob

Flame
Adjustment
Knob

TO TURN OFF GAS

TO APPLIANCE

Shutting Off Heater
1. Turn control knob clockwise

to the

OFF position.

2a. Set switch in the OFF position.

2b. If Using Optional Hand-Held Remote:

Set selector switch in the OFF position to

prevent draining battery.

Shutting Off Burner Only (pilot stays lit)

You may shut off the burner and keep the pilot

lit by doing one of the following:
1. Turn control knob clockwise

to the

PILOT position.

2. Use remote control manual OFF button.

3. Set selector switch in the OFF position.

MANUAL LIGHTING

PROCEDURE

1. Follow steps 1 through 6 under Lighting

Instructions, page 17.

2. Depress control knob and light pilot with

match.

3. Keep control knob pressed in for 30 seconds

after lighting pilot. After 30 seconds, release

control knob. Now follow steps 9 through

11, Lighting Instructions, page 17.

Figure 19 - Pilot

Ignitor
Electrode

Pilot
Burner

Natural

Ignitor Electrode

Pilot
Burner

Propane/LP

CAUTION: Do not try to ad-

just heating levels by using the

equipment shutoff valve.

WARNING: Make sure the

selector switch is in the OFF
position  when  you  are  away
from  home  for  long  periods
of  time.  Heater  will  come  on
automatically  with  selector
switch in the ON position.