Sony PFM-510A1WU Manual
10
(GB)
2
5
8
ZOOM
DISPLAY
RGB2
Y/C
SELECT
VOL
3
6
9
CH
DEGAUSS
POWER
YUV
MTS/MPX
CH
1
4
7
10/0
STILL
MUTING
RGB1
LINE
MENU
ENTER
ON
OFF
ON
POWER
ID MODE
SET
OFF
qs
qd
qf
qg
qh
qj
qk
ql»
w;…
wa
1
2
3
4
5
6
7
8
9
0
qa
Left Connector Panel
1
MONITOR OUT AUDIO (L/R) jacks (phono
type)
Output the signal input from the AUDIO IN jacks.
Connect to the audio inputs of an audio amplifier (not
supplied).
Output the signal input from the AUDIO IN jacks.
Connect to the audio inputs of an audio amplifier (not
supplied).
Note
These jacks are variable outputs. Set the volume to
maximum position to set the output level to
500 mVrms.
maximum position to set the output level to
500 mVrms.
2
CONTROL S IN/OUT jacks (mini jacks)
Connect to the CONTROL S jacks of video
equipment or another monitors. Then you can
simultaneously control all equipment with a single
Remote Commander.
To control equipment by aiming the supplied Remote
Commander to the remote control detector of the
monitor, connect the CONTROL S OUT jack of the
monitor and the CONTROL S IN jack of other
equipment.
equipment or another monitors. Then you can
simultaneously control all equipment with a single
Remote Commander.
To control equipment by aiming the supplied Remote
Commander to the remote control detector of the
monitor, connect the CONTROL S OUT jack of the
monitor and the CONTROL S IN jack of other
equipment.
Notes
• If you connect the CONTROL S IN jack to the other
equipment’s CONTROL S OUT jack, you cannot
operate the monitor with the Remote Commander.
operate the monitor with the Remote Commander.
• You can use the stereo cable with mini plug instead
of the control S cable.
3
SPEAKERS L/R terminals
Connect to speakers with 6 to 16 ohms impedance.
Note
Do not connect the speaker’s cord to the monitor and
to an amplifier simultaneously, or an excessive
electric current might flow from the amplifier and
damage the monitor.
to an amplifier simultaneously, or an excessive
electric current might flow from the amplifier and
damage the monitor.
4
SERVICE CODE indicator
The indicator is only for qualified personnel.
5
-AC IN socket
Connect the supplied AC power cord to this socket
and to a wall outlet. Once you connect the AC power
cord, the monitor turns to standby mode.
and to a wall outlet. Once you connect the AC power
cord, the monitor turns to standby mode.
Remote Commander RM-921
MONITOR OUT
CONTROL S
SPEAKERS
(6-16
Ω
)
AC IN
SERVICE CODE
AUDIO
R
L
IN
+
R–
+
L
–
OUT
VARIABLE
5
4
3
2
1
8.8.
Location and Function of Parts and Controls