Nortel Networks 4400 User Manual
30 Chapter 3 Hardware Setup
209664-A
Installing Passport 4460 Hardware
The next four steps must be executed before you can operate your Passport 4460
unit.
unit.
Installation information can be found in the Reference for Passport 4460
Hardware, (205677-A).
Hardware, (205677-A).
1
Install the Flash card, Chapter 4
2
Attach the interface cables, Chapter 6 (also refer to Reference for Passport
4400 Cables, 205678-A)
4400 Cables, 205678-A)
3
Connect the workstation, Chapter 7
4
Power up your Passport 4460 unit, Chapter 1
In Chapter 1 of this manual, you were asked to evaluate the device management
tools you are going to use. Refer to the table below and then go to the next
procedure.
tools you are going to use. Refer to the table below and then go to the next
procedure.
If you are using any of the network management tools, refer
and
Also note that the Configuring and Operation Passport 4400 Rel. 4 Software will
be a good source of product and parameter information as you configure your
unit.
be a good source of product and parameter information as you configure your
unit.
If you are using....
Refer to....
Passport 4400 Configurator
Chapter 4 of this manual
Command Line Interface (CLI)
Chapters 5 and 6 of this manual
Install Tool
Using Passport 4400 Install Tool Version
4.1, 206906-B
4.1, 206906-B
Mass Deployment and Reporting Tool
Using the Passport 4400 Mass Deployment
and Reporting Tool, 209665-A
and Reporting Tool, 209665-A