Paradyne CSU User Manual

Page of 470
7. Operation and Maintenance
9128-A2-GB20-80
September 2002
7-25
RLB Active, 
[Interface]
A network Repeater Loopback (RLB) is active on the 
specified interface.
Secondary Clock Failed
A failure of the secondary clock source configured for 
the unit is detected and the internal clock is providing 
the timing for the unit.
The clock source will not automatically switch from 
internal until the primary clock source returns. 
Send
 Pattern Active, DLCI nnnn, 
frame_relay_link
1,2
A Send Pattern test is currently active on the 
specified DLCI on the specified frame relay link.
Send
 Pttn Active, [Interface]
A Send Pattern test is active on the specified 
interface using a selected test pattern.
This test cannot be activated on user data ports that 
have Port Use set to Frame Relay.
SLV Latency Exceeded, 
DLCI 
nnnn, frame relay link
1, 2, 3
The measured latency of SLV communication 
responses from the remote unit on this DLCI is 
excessive, so the DLCI has been declared unsuitable 
for normal multiplexed PVC operation (DLCI Type is 
set to Multiplexed).
SLV Timeout, DLCI 
nnnn, 
frame relay link
1, 2, 3
An excessive number of SLV communication 
responses from the remote FrameSaver SLV unit 
have been missed on the specified multiplexed DLCI; 
the DLCI is not suitable for user data.
When a hardware bypass capable device has been 
detected at the other end of the PVC and this 
condition occurs, only user data for EDLCI 0 will be 
transmitted while this condition exists.
When an ISDN DBM is present, this message only 
appears for individual and aggregate multilink frame 
relay links, not constituent links of a frame relay 
multilink.
Suboptimal Link Rate, 
frame relay link
2
(ISDN DBM only)
The specified frame relay multilink has failed to 
achieve the configured Maximum Link Rate for the 
link.
This message appears for multilink aggregate frame 
relay links if LMI is down on any of its constituent 
links.
Table 7-8.
Health and Status Messages (6 of 7) 
Message
What It Indicates
1
nnnn indicates a DLCI number of 16 through 1007.
2
frame relay link is one of the following: 
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port-
n. The frame relay link associated with the user data port.
– 
ISDN Link Name on a non-network ISDN DBM interface.
3
Does not apply to a TS Management Link DLCI.