Paradyne CSU User Manual
8. Troubleshooting
8-14
September
2002
9128-A2-GB20-80
Viewing the Trap Event Log
The Trap Event Log displays all traps stored in the SNMP trap event log. ASCII
trap strings used to describe trap events are provided in the tables contained in
trap strings used to describe trap events are provided in the tables contained in
Standards Compliance for SNMP Traps
(see
).
See
, for a screen
example and additional information.
Troubleshooting Tables
The unit is designed to provide many years of trouble-free service. However, if a
problem occurs, refer to the appropriate table in the following sections for possible
solutions.
problem occurs, refer to the appropriate table in the following sections for possible
solutions.
Device Problems
Table 8-2.
Device Problems (1 of 2)
Symptom
Possible Cause
Solutions
No power, or the LEDs
are not lit.
are not lit.
The power cord is not
securely plugged into the
wall receptacle to rear panel
connection.
securely plugged into the
wall receptacle to rear panel
connection.
Check that the power cord is
securely attached at both ends.
securely attached at both ends.
The wall receptacle has no
power.
power.
Check the wall receptacle
power by plugging in some
equipment that is known to be
working.
power by plugging in some
equipment that is known to be
working.
Check the circuit breaker.
Verify that your site is not on an
energy management program.
energy management program.
Power-On Self-Test
fails. Only Alarm LED
is on after power-on.
fails. Only Alarm LED
is on after power-on.
The unit has detected an
internal hardware failure.
internal hardware failure.
Reset the unit and try again.
Contact your service
representative.
representative.
Return the unit to the factory
(refer to
(refer to
document).