Paradyne CSU User Manual

11. Setting Up Network Health for FrameSaver Devices

  

September 

2002

9128-A2-GB20-80

For additional information about installing, accessing, and managing FrameSaver 
SLV devices through Concord’s Network Health, and for information about 
applicable reports, refer to:

„

Network Health Installation Guide

 to help you install the application.

„

Network Health User Guide

  to help you get started using the application.

„

Network Health Reports Guide

 to help you understand and use Frame Relay 

reports.

„

Network Health – Traffic Accountant Reports Guide

 to help you understand 

and use Traffic Accountant reports.

Refer to the 

Network Health Installation Guide

 for installation instructions, and 

follow the instructions applicable to your network platform. Once Network Health is 
installed, you need to set up the application so it will support FrameSaver units.

Each Network Health application provides a different set of functions, called a 
module. Each module used requires a separate license to gain access to those 
features and functions. Make sure you license the Poller application so you can 
poll SLV units and collect data.

To use this application:

1. Discover network elements, units, and interfaces in the network.

2. Configure the Network Health applications, then save them.

3. Organize elements into groups for reporting purposes.

4. Set up and run reports.

Setup and operation information is contained in the 

Network Health User Guide

. 

The sections that follow address only the minimal procedural steps needed once 
you have access to the applications. 

See the Network Health User and Reports Guides for additional startup 
information and a full discussion of the application’s features and how to use them.