Paradyne CSU User Manual

Page of 470
B. SNMP MIBs and Traps, and RMON Alarm Defaults
B-12
  
September 
2002
9128-A2-GB20-80
Physical Sublayer 
(continued)
BRI
(Supported through 
ifIndex – RFC 1573.)
„
ifIndex (RFC 1573)
„
ifAdminStatus 
(RFC 1573)
„
ifOperStatus (RFC 1573)
„
devLastTrapString 
(devHealthAndStatus.-
mib)
„
linkDown – One or more alarm 
conditions are active on the 
interface.
Strings: 
‘$ifString down.’ No alarms 
exist on the link.
‘$ifString administratively 
shutdown.’ (Due to an 
intentional shutdown.)
„
linkUp – No alarms on the 
interface.
String: 
‘$ifString up.’
Logical Link Sublayer
T1 Network, 
BRI, 
PRI, 
Synchronous Data 
Port
Service Side of the 
Frame Relay UNI
(Supported by the 
media-specific Frame 
Relay Services MIB.)
„
ifIndex (RFC 1573)
„
ifAdminStatus (RFC 
1573)
„
ifOperStatus (RFC 1573)
„
devLastTrapString 
(devHealthAndStatus.-
mib)
„
linkDown – LMI is down for the 
LMI Protocol configured,
 or 
Frame Relay link is disabled.
Strings: 
‘$ifString down.’ No alarms 
exist on the link due to LMI.
‘$ifString LMI down.’ No alarms 
exist on the link. (e.g., ‘Sync 
Data Port S01P1 frame relay 
link “Port-1” LMI down.’ )
‘$ifString administratively 
shutdown.’ (Due to an 
intentional shutdown.)
„
linkUp – LMI is up or Frame 
Relay link is enabled.
String: 
‘$ifString up.’
T1 Network, 
BRI, 
PRI, 
Synchronous Data 
Port
DTE Side of the Frame 
Relay UNI
(Supported by the 
media-specific Frame 
Relay DTE’s MIB.)
„
ifIndex (RFC 1573)
„
ifAdminStatus (RFC 
1573)
„
ifOperStatus (RFC 1573)
„
devLastTrapString 
(devHealthAndStatus.-
mib)
„
linkDown – LMI is down for the 
LMI Protocol configured,
3
 or 
Frame Relay link is disabled.
Strings: 
‘$ifString LMI down.’
‘$ifString administratively 
shutdown.’ (Due to an 
intentional shutdown.)
„
linkUp – LMI is up or Frame 
Relay link is enabled.
String: 
‘$ifString up.’
Table B-6.
linkUp and linkDown Variable-Bindings (2 of 2) 
Interface
Variable-Bindings
Possible Cause
1
The DTR alarm condition will only generate a linkUp/ linkDown trap if the DTE 
supports the DTR lead state.
2
The RTS alarm condition will only generate a linkUp/ linkDown trap if the DTE 
supports the RTS lead state.
3
If the LMI Protocol is not configured, a linkUp/linkDown trap is based solely upon 
whether the interface is enabled or disabled.