Paradyne CSU User Manual
C. Router CLI Commands, Codes, and Designations
9128-A2-GB20-80
September 2002
C-13
ip
nat
pool
pool-name start-ip-addr end-ip-addr
{
netmask
netmask
| {
prefix-length
|
/
}
prefix-length
}
no
ip
nat
pool
pool-name
[
start-ip-addr end-ip-addr
{
netmask
netmask
| {
prefix-length
|
/
}
prefix-length
} ]
Minimum Access Level: Administrator
Command Mode: config
Command Mode: config
Defines a pool of addresses for Network Address Translation. Addresses can then be
allocated from the pool as needed. Up to 30 NAT pools can be supported.
allocated from the pool as needed. Up to 30 NAT pools can be supported.
To remove a pool, use the
no ip nat pool
command. No NAT pools are configured by
default.
Example:
ip nat pool Largo 132.53.4.2 132.53.4.250 / 24
pool-name – Name of the pool comprised of 1–20 ASCII printable characters.
start-ip-addr – Starting IP address of the range of addresses in the address pool.
end-ip-addr – Ending IP address of the range of addresses in the address pool.
netmask – Specify a network mask that indicates which address bits belong to the
network and subnet fields, and which bits belong to the host field.
network and subnet fields, and which bits belong to the host field.
netmask – Network mask of the network for the pool addresses.
prefix-length or / – Specify the number of bits in a network mask address that are
ones and define the network and subnet fields.
ones and define the network and subnet fields.
prefix-length – The number of bits in a network mask address that are ones. Valid
range is 1–32.
range is 1–32.
[
no
]
ip
nat
inside
source
{
list
access-list-1-99num
pool
pool-name
[
overload
] |
list
access-list-1-99num
interface
intf-type
intf-num
[
.sub-intf-num
]
overload
|
s
tatic
{
static-ip-addr1
static-ip-addr2
|
protocol
static-ip-addr1 static-port-num
static-ip-addr2
} }
Minimum Access Level: Administrator
Command Mode: config
Command Mode: config
Allows a user to specify or remove Network Address Translation rules. Both dynamic and
static address translations may be specified. Command forms that include an access list
are used to specify dynamic translation rules. Packets from addresses that match the
access list are translated using addresses allocated from the named pool or the IP
address assigned to the interface. No NAT rules are configured by default.
static address translations may be specified. Command forms that include an access list
are used to specify dynamic translation rules. Packets from addresses that match the
access list are translated using addresses allocated from the named pool or the IP
address assigned to the interface. No NAT rules are configured by default.
Example: Refer to
inside – Inside address translation converts an inside (private) IP address to an outside
(public) IP address (and port, if overload is specified for NAPT).
(public) IP address (and port, if overload is specified for NAPT).
source – Specifies source address translation.
list – Specify the access list number for dynamic address translation. For inside source
translation, this access list describes local addresses. If no rules have been created for
the specified access list, no translations based on this rule will occur.
translation, this access list describes local addresses. If no rules have been created for
the specified access list, no translations based on this rule will occur.
access-list-1-99num – A standard IP Access list. The valid range is 1–99.
(Continued on next page)
Table C-8.
NAT Commands (2 of 3)