Paradyne CSU User Manual

Page of 470
C. Router CLI Commands, Codes, and Designations
C-22
  
September 
2002
9128-A2-GB20-80
[
no
ip
 
access-group
 
access-list-1-199num
 [
in
  |  
out
]
Minimum Access Level: Administrator
Command Mode: config-if
Allows you to control access to an interface by allowing you to designate (or delete) a set 
of access rules to be applied to either incoming or outgoing packets. By default, no access 
lists are applied to interfaces.
Example: ip access-group 17 in
NOTE: A user may specify that an access list is applied to either inbound packets, 
outbound packets, or both inbound and outbound packets (two commands). If a 
specified access list does not exist, all packets are passed.
access-list-1-199num – The access list number. The valid ranges for access lists are:
1– 99 – Standard IP access lists.
100 –199 – Extended IP access lists.
in – Specifies that filters will be applied to inbound packets.
out – Specifies that filters will be applied to outbound packets. If no direction (in or out) is 
specified, the filter is applies to outbound packets by default.
Table C-11. Filter Commands (4 of 4)