Paradyne CSU User Manual

Page of 470
C. Router CLI Commands, Codes, and Designations
C-26
  
September 
2002
9128-A2-GB20-80
show
 
configuration 
{
saved
 | 
unsaved
Minimum Access Level: Administrator
Command Mode: All config modes
Displays/outputs a sequence of commands in the form of ASCII strings that have the 
effect of setting all configurable parameters to the current values, either saved in memory 
or entered during a current configuration session. 
Passwords are write-only and not output. The text file can be used with a terminal 
emulation program. Refer to 
Configuring the FrameSaver SLV Router. The general format of the show 
config command is the same as the previous command, show configuration, in Standard 
mode.
saved – Displays the command sequence for saving parameters currently saved in 
memory.
unsaved – Displays the command sequence for saving parameters entered during the 
current configuration session.
show frame-relay map
Minimum Access Level: Operator
Command Mode: Standard
Displays the status of all frame relay DLCIs seen on the router’s frame relay interface.
The general format of the 
show frame-relay map
 command is:
interface (interface-status): dlci dlci-number, dlci-status 
Where the 
interface (or sub-interface) shall be displayed in the standard format shown in 
the Interface Commands. The 
interface-status is up or down. The dlci-number is in the 
range 16 –1007. Frame relay map statements are only displayed for DLCIs configured on 
both the router and on the devices user interface. The 
dlci-status is active or inactive.
show
 
interface
 [
intf-type intf-num
 [
.sub-intf-num
]]
Minimum Access Level: Operator
Command Mode: Standard
Shows the status of the named interface, sub-interface, or all interfaces and 
sub-interfaces on the device.
intf-type – The interface type. The following two types are supported:
Ethernet – IEEE 802.3 interface
Serial – Serial interface
intf-num – The interface index number for the Ethernet and the Serial interfaces: 0.
sub-intf-num – The sub-interface numbers are only supported on the Network interface 
(Serial 0). Sub-interface numbers supported: 0– 4,294,967,295.
Table C-13. Show Commands (2 of 4)