IBM IBM UPS 10000XHV User Manual

15

 

S

ETTINGS ARE MADE THROUGH THE SUPPLIED 

P

OWER

C

HUTE 

B

USINESS 

E

DITION SOFTWARE

,

 

N

ETWORK 

M

ANAGEMENT 

C

ARD

,

 OR TERMINAL MODE

.

 

R

EFER TO THE SOFTWARE HELP GUIDES FOR DETAILS

. 

Output Frequency 

Automatic 

(50 

±  3 Hz or 

60 

± 3 Hz) 

Automatic, 
50 

±  3 Hz, 

50 

±  0.1 Hz, 

60 

±  3 Hz, 

60 

±  0.1 Hz 

The user is able to set the allowable 
uninterruptible power supply output 
frequency. Whenever possible, the 
output frequency tracks the input fre-
quency. 

Number of Battery 
Packs 

1 

Number of Con-
nected Battery Packs 
(four battery modules 
per pack) 

The user can define the number of con-
nected battery packs for proper runtime 
prediction. 

The output power can be disabled in an emergency by closing a switch connected to the EPO. 

Note: Adhere to national and local electrical codes when wiring. 

The switch should be connected in a normally open switch contact. External voltage is not required; the switch is powered by a 
12 V internal power supply. A closed switch draws 2 mA of current. 

The EPO switch is internally powered by the uninterruptible power supply for use with non-powered switch circuit breakers. 

Note: The EPO circuit is considered a Class 2 circuit, (UL, CSA standards) and an SELV circuit (IEC standard). 

Both Class 2 and SELV circuits must be isolated from all primary circuitry. Do not connect any circuit to the EPO terminal 
block unless it can be confirmed that the circuit is Class 2 or SELV. 

If the circuit standard cannot be confirmed, use a contact closure switch.

 

Use one of the following cable types to connect the uninterruptible power supply to the EPO switch: 

• 

CL2: Class 2 cable for general use 

• 

CL2P: Plenum cable for use in ducts, plenums, and other spaces used for environmental air 

• 

CL2R: Riser cable for use in a vertical run in a floor-to-floor shaft 

• 

CLEX: Limited use cable for use in dwellings and for use in raceways 

• 

For installation in Canada: Use only CSA certified, type ELC (extra-low voltage control cable) 

• 

For installation in other countries: Use a standard low-voltage cable according to local regulations