3com 3C16405 User Manual
DUA1640-5AAA02
3-8
C
HAPTER
3: U
SING
THE
PS H
UB
Rack and Wall
Mounting
Mounting
Two mounting brackets and four screws are supplied with the hub.
These are used for rack mounting and wall mounting the hub.
These are used for rack mounting and wall mounting the hub.
CAUTION: Disconnect all cables from the hub(s) before continuing.
Remove the self-adhesive rubber feet from the underside of the hub,
if already fitted.
Remove the self-adhesive rubber feet from the underside of the hub,
if already fitted.
Rack Mounting
The hub is 1U high and fits a standard 19in. rack.
To rack mount the hub:
1 Place the hub the right way up on a hard, flat surface with the front
facing towards you.
2 Locate a mounting bracket over the mounting holes on one side of the
hub, as shown in Figure 3-2.
Figure 3-2 Locating the Brackets for Rack Mounting
3 Insert the two screws and fully tighten with a suitable screwdriver.
4 Repeat the two previous steps for the other side of the hub.
5 Insert the hub into the 19in. rack and secure with suitable screws
(not provided).