Panasonic CR-SRF100 User Guide
CR-SRF100/CR-SRT100
8
5. Getting Initial Subscription
For Channels From Sirius
Only continue with this section after the system is installed in the vehicle and the battery is connected.
There are 3 basic steps:
1. Turn the power on by pressing the [SEL] knob/button.
(the unit’s Sirius ID number should be displayed)
(if the ID number is not displayed, skip this section … already subscribed!)
Note: If this is the first time the radio has been powered on, please leave the unit powered up for
approximately 5 minutes without operating the controls. There is transmission-specific information which
must be loaded into the receiver from the satellite signal.
approximately 5 minutes without operating the controls. There is transmission-specific information which
must be loaded into the receiver from the satellite signal.
2. Record the receiver’s product serial number (printed on a label on the receiver) and Sirius ID number
from the display. (See section 6.1 for information on displaying the Sirius ID.)
from the display. (See section 6.1 for information on displaying the Sirius ID.)
If your system has been powered up and a subscription for satellite
services has already been done, then SKIP this section...you are ready to
finish setting up the system or operate it.
17233_SGould 08/15/02 14:46 Page 8