ATTO Technology 1180D User Guide
17
ATTO Technology Inc. FibreBridge Installation and Operation Manual
Installation instructions
1
Physically place the FibreBridge on a desktop
or into a rack.
or into a rack.
a. To mount on a rack, install “L” brackets
so that either the front or the connector
side of the FibreBridge faces front. The
mounting holes on the bracket fit a
standard 19-inch rack using a centered
1.25-inch (31.7 mm) hole pattern.
side of the FibreBridge faces front. The
mounting holes on the bracket fit a
standard 19-inch rack using a centered
1.25-inch (31.7 mm) hole pattern.
b. Install the FibreBridge horizontally
within the rack so it does not reduce the
air flow.
air flow.
Note
The power requirements of the ATTO
FibreBridge plus the power draw of the other
equipment in the rack must not overload the
supply circuit and/or wiring of the rack.
FibreBridge plus the power draw of the other
equipment in the rack must not overload the
supply circuit and/or wiring of the rack.
c. Properly ground the FibreBridge to the
rack equipment. The earth ground
connection must be maintained.
connection must be maintained.
2
Connect a SCSI device to the FibreBridge.
Connect the Fibre Channel port to your
SAN.Connect the Ethernet cable from the Fibre
Bridge to your computer. Refer to
Connect the Fibre Channel port to your
SAN.Connect the Ethernet cable from the Fibre
Bridge to your computer. Refer to
3
Connect the power connector.
4
Apply power.
5
Access FibreBridge Services using the
QuickNAV utility. Refer to
QuickNAV utility. Refer to
6
Go to the ExpressNAV Restart page and
restart the FibreBridge.
restart the FibreBridge.
7
Map your devices.Refer to
8
Boot the computers on the SAN and check the
configuration. Refer to
configuration. Refer to
Additional
configurations
on page 17.
Exhibit 1.5-2 FibreBridge 2300R/D schematic: top view