Enterasys 6000 User Guide
Configuring SNA
8-19
Configuring a Virtual LAN ID
A virtual LAN ID is normally assigned by a system administrator. The ID is used
internally by the FRX/FRM to identify a virtual bridge that connects the LLC2
function to LAN interfaces.
internally by the FRX/FRM to identify a virtual bridge that connects the LLC2
function to LAN interfaces.
If LLC2 will run in the local node, press
[B]
at the Configure LAN Default Parameters
Menu
(or
[A], [A], [E], [B]
from the Main Menu). When prompted, enter:
●
Virtual LAN ID:
0–fff
(hex). (The default is
000
.)
LAN IDs can also be configured in LLC2 Interface/Bridge Port
records (later in this chapter). Each LAN ID must be unique
within the network on which this node will operate.
records (later in this chapter). Each LAN ID must be unique
within the network on which this node will operate.
●
If also configuring Bridging in the node, address the remaining parameters as
described in Chapter 13. Otherwise, press
described in Chapter 13. Otherwise, press
[Enter]
(accepting the default) for
each remaining parameter, since they are not used for LLC2.
Figure 8-5 LLC2 Defaults Configuration Screen
[A],[A],[E],[B
] from Main Menu
Only item A applies to LLC2. Leave the remaining parameters at their
default values.
default values.
Nod e Name=nod exyz
Con figu re Bridge/LLC2 N ode D efau lts
A Virtu al LAN ID
000
B Bridge En abled
N
C Bridge Hello Time
2
D Bridge Max A ge
20
E Bridge Forward D elay
15
F Bridge A gin g Timer (secon ds)
300
G Bridge Priority
0
H Max Size Bridge Forwarding Tab le
65535
I
IP Brid gin g En abled
N
J
IPX Bridging En abled
N
K SRB ID
0
L Defau lt Ethernet Frame Type
Type I I
Option: