Sony kdl-40s4100 User Guide

This TV can be installed on a wall by using a Wall-Mount Bracket (sold 
separately). Before mounting the TV on a wall, the Table-Top Stand must be 
removed from the TV.

Follow the simple steps below to remove the Table-Top Stand:

Disconnect all the cables from the TV.

Secure the Mounting Hook to the rear of the TV.

Adjust the angle of the Mounting Hook.

Start removing the screws behind the TV (See illustration below). Do 
not remove any other screws from the TV.

When screws are removed, lift the TV off the stand. Make sure that you 
carry out this task with at least two people. Do not attempt to lift the TV 
by yourself.

For bracket installation, refer to the instruction guide provided by the Wall-
Mount Bracket model for your TV. Sufficient expertise is required in 
installing this TV, especially to determine the strength of the wall for 
withstanding the TV’s weight. For product protection and safety reasons, 
Sony strongly recommends that you use the Wall-Mount Bracket model 
designed for your TV and the wall-mounting of your TV should be 
performed by Sony dealers or licensed contractors.

Be sure to use the screws supplied with the Wall-Mount Bracket when 
attaching the mounting hooks to the TV set. The supplied screws are 
designed so that they are 8 mm to 12 mm in length when measured from the 
attaching surface of the mounting hook. The diameter and length of the 
screws differ depending on the Wall-Mount Bracket model. Use of screws 
other than those supplied may result in internal damage to the TV set or 
cause it to fall, etc.

Do not remove the Table-Top Stand for any reason other than to wall-
mount the TV.

8-12 mm

Screw (supplied with the Wall-Mount Bracket)

Mounting Hook

Rear of the TV set