Bosch ex70c704-n Installation Instruction
11
4. CAMERA / LED ADJUSTMENTS
For optimum picture quality, the EX70 camera
lens must be as close as possible to the inside
face of the viewing window, without touching.
However, the foam ring around the lens of the
EX70N should be adjusted to seal against the
inside face of the window, minimizing any side
light interference, but without obstructing the
field of view.
lens must be as close as possible to the inside
face of the viewing window, without touching.
However, the foam ring around the lens of the
EX70N should be adjusted to seal against the
inside face of the window, minimizing any side
light interference, but without obstructing the
field of view.
The lens clearance adjustment can be achieved
via the two side screws on the camera bracket.
The complete VRB/camera/LED Array chassis
must be removed from the base housing for this
adjustment. See Figure 4 – 1 for details.
via the two side screws on the camera bracket.
The complete VRB/camera/LED Array chassis
must be removed from the base housing for this
adjustment. See Figure 4 – 1 for details.
The lens viewing direction can be also slightly
adjusted via the two side screws.
See Figure 4 – 2.
For larger lens viewing angles adjustments it is
recommended that the entire camera housing be
tilted on a separate bracket.
The LEDs on the LED array board can be
adjusted for brightness. See Figure 4 – 3.
adjusted via the two side screws.
See Figure 4 – 2.
For larger lens viewing angles adjustments it is
recommended that the entire camera housing be
tilted on a separate bracket.
The LEDs on the LED array board can be
adjusted for brightness. See Figure 4 – 3.