EIKI EIP-5000 User Manual
23
Controlling the Projector via LAN
Controlling the Projector
Using Internet Explorer
Using Internet Explorer
(Version 5.0 or later)
Complete connections to external equipment
before starting the operation. (See pages 24-
36 on the owner’s manual of the projector.)
Complete the AC cord connection. (See page
37 on the owner’s manual of the projector)
before starting the operation. (See pages 24-
36 on the owner’s manual of the projector.)
Complete the AC cord connection. (See page
37 on the owner’s manual of the projector)
Note
• When connecting the projector to the LAN, use a
commercially available LAN cable (UTP cable,
Category 5, cross-over type). When connecting
the projector to a hub, use a straight-through cable.
Category 5, cross-over type). When connecting
the projector to a hub, use a straight-through cable.
1
Start Internet Explorer (version 5.0
or later) on the computer.
or later) on the computer.
2
by “/” in “Address”, and then
press the “Enter” key.
press the “Enter” key.
• The default setting (“DHCP Client” is set to
“OFF” on the projector) for IP address is
“192.168.150.2”. If you did not change the IP
address in “3. Setting up a Network Con-
nection for the Projector” (pages
“192.168.150.2”. If you did not change the IP
address in “3. Setting up a Network Con-
nection for the Projector” (pages
),
enter “http://192.168.150.2/”.
3
A screen for controlling the pro-
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
After connecting the projector to your network, enter the projector IP address in “Address”
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.