EIKI EIP-3500 Installation Instruction
12
Controlling the Projector via LAN
Controlling the Projector
Using Internet Explorer
Using Internet Explorer
(Version 5.0 or later)
Complete connections to external equipment
before starting the operation. (See pages 21-
28 of the projector’s operation manual.)
Complete the AC cord connection. (See page
29 of the projector’s operation manual.)
before starting the operation. (See pages 21-
28 of the projector’s operation manual.)
Complete the AC cord connection. (See page
29 of the projector’s operation manual.)
Note
• When connecting the projector to the LAN, use
a LAN cable (Category 5). When connecting the
projector to a hub, use a straight-through cable.
projector to a hub, use a straight-through cable.
1
Start Internet Explorer (version 5.0
or later) on the computer.
or later) on the computer.
2
Enter “http://” followed by the
projector IP address set by the
procedure on page
projector IP address set by the
procedure on page
11
followed
by “/” in “Address”, and then
press the “Enter” key.
press the “Enter” key.
• The factory default setting for the projector
IP address is 192.168.150.2. If you did not
change the IP address in “3. Setting up a
Network Connection for the Projector”
(page
change the IP address in “3. Setting up a
Network Connection for the Projector”
(page
10-11)
, enter “http://192.168.150.2/”.
3
A screen for controlling the pro-
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
jector appears, ready for per-
forming various status condi-
tions, control, and settings.
After connecting the projector to your network, enter the projector IP address in “Address”
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.
on Internet Explorer (version 5.0 or later) using a computer on the network to start a setup
screen that will enable control of the projector via the network.