Sanyo PLC-XM100 User Guide

The command is sent from PC to the projector with the 

format below;

     

'CR' [Command] 'CR'

     

 Command: one character (refer to the command table 

below.

The projector decodes the command and returns the 

'Character string' with the format below;

The tables on page 87 and 88 show the typical command lists for controlling the projector.  Please consult your local dealer 

for further information of other commands.

Command

Function

Projector 

Return

Projector status

CR0

Status Read

00

Power On

80

Stand-by mode

40

Countdown

20

Cooling down

10

Power Malfunction

28

Cooling down at the temperature anomaly

24

Cooling down at Power Management mode

04

Power Management mode after Cooling down

21

Cooling down after the projector is turned off when the lamps 
are out.

81

Stand-by mode after Cooling down when the lamps are out.

88

Stand-by mode after Cooling down at the temperature 
anomaly.

2C

Cooling down when the projector is turned off by the shutter 
management function.

8C

Stand-by mode after cooling down by the shutter management 
function. 

CR6

Temperature Read

S1 S2 S3

S1 = Temperature at Sensor 1 (˚C)
S2 = Temperature at Sensor 2 (˚C)
S3 = Temperature at Sensor 3 (˚C)
(ex.) S1 = 12.3˚C,  S2 = 23.4˚C, S3 = 34.5˚C
 --> The projector displays “12.3 23.4 34.5”
    ( For each sensor, two digit and the tenth place numbers are 

displayed with a space between each temperature.)

?

Communication failure