Audiovox avr2000 Instruction Manual
RADIO OPERATION
1. Press the TUNER/BAND button on the unit or the FUNCTION button on the remote control until the frequency
band appears on the display.
2. Press the TUNER/BAND button again or the BAND button on the remote control to select the desired band.
3. Press either of the TUNING buttons to tune into a station.
3. Press either of the TUNING buttons to tune into a station.
FM Stereo
Press the MONO/STEREO button on the remote control until “STEREO” appears on the display. When the
radio signal is weak, the “ ((ST)) ” indicator will flash.
Press the MONO/STEREO button on the remote control until “STEREO” appears on the display. When the
radio signal is weak, the “ ((ST)) ” indicator will flash.
Weak FM Stations
Press the MONO/STEREO button until “MONO” appears on the display. Background noise will be reduced but
the signal reproduced will be mono. To restore stereo reception, press the MONO/STEREO button again.
Press the MONO/STEREO button until “MONO” appears on the display. Background noise will be reduced but
the signal reproduced will be mono. To restore stereo reception, press the MONO/STEREO button again.
• Hold down either of the TUNING buttons on the unit or the remote control for 1 to 2 seconds, and a station
is searched automatically. After tuning into a station, the search stops.
• The search may not stop at a station with a very weak signal.
• When the search is in progress, press either of the TUNING buttons again to stop searching.
• When the search is in progress, press either of the TUNING buttons again to stop searching.
You can tune into a stored station directly by pressing the PRESET button.
20 stations on FM band can be preset.
20 stations on AM band can be preset.
1. Press the TUNER/BAND button on the unit or the FUNCTION button on the remote control until the frequency
20 stations on FM band can be preset.
20 stations on AM band can be preset.
1. Press the TUNER/BAND button on the unit or the FUNCTION button on the remote control until the frequency
band appears on the display.
2. Press the TUNER/BAND button on the unit again or the BAND button on the remote control to select the
desired band.
3. Use the TUNING button to find your desired station.
4. Press the MEMORY button on the remote.
5. Press the NEXT or PREV button to select the preset number and press the MEMORY button on the remote
4. Press the MEMORY button on the remote.
5. Press the NEXT or PREV button to select the preset number and press the MEMORY button on the remote
control to store the station.
6. Repeat steps 2-5 to store other stations.
7. To change the preset station. Repeat steps 2-5.
7. To change the preset station. Repeat steps 2-5.
1. Press the TUNER/BAND button on the unit or the FUNCTION button on the remote control until the frequency
band appears on the display.
2. Press the TUNER/BAND button again or the BAND button on the remote control to select the desired band.
3. Press the PRESET button on the unit repeatedly or the NEXT or PREV button to select the preset station.
4. To check the preset stations. Press the PRESET button repeatedly.
Notes:
• Only the two front speakers and the subwoofer are active in tuner mode.
• The SURROUND and TEST buttons on the remote control are unavailable in tuner mode.
3. Press the PRESET button on the unit repeatedly or the NEXT or PREV button to select the preset station.
4. To check the preset stations. Press the PRESET button repeatedly.
Notes:
• Only the two front speakers and the subwoofer are active in tuner mode.
• The SURROUND and TEST buttons on the remote control are unavailable in tuner mode.
9
To Tune Into a Station Manually
To Search for a Station Automatically
To Preset Stations
To Tune Into a Preset Station