TallyGenicom 2440 User Guide

6-3

The top margin is wrong.

The top margin is the sum of the printer’s top-of-
form setting, the software-specified top margin, 
and the printer’s TOP-MARGIN setting. Proceed 
as follows:

•

Make sure that the top-of-form setting is correct. 
The factory default is 0 mm (0 inch).

•

Check the software-specified top margin. Refer 
to your software documentation.

•

Check the printer’s TOP-MARGIN setting. See 
the section “COMMON (PUSH TRAC) menu” or 
“FRICTION menu” in Chapter 4, “Special mode”.

Lines are double spaced instead 
of single spaced.

Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR. See “SET-UP menu” in 
Chapter 4, “Special mode”.

The printer overprints on the 
same line.

Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR. See “SET-UP menu” in 
Chapter 4, “Special mode”.

The next print line starts where 
the previous line ended instead 
of at the left margin.

Change the CR CODE setting in the printer Set-
Up mode to LF=LF+CR. See “SET-UP menu” in 
Chapter 4, “Special mode”.

The printer overprints on the 
same line while the next print 
line starts where the previous 
line ended instead of at the left 
margin.

Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR and LF=LF+CR. See 
“SET-UP menu” in Chapter 4, “Special mode”.